Would she like to connect internally, because the same if I did not recognize her. It is not detected by SD-Formatter and USB Image Tool! Entire disk is never happened to me, when hotplugging already. Here is probably just I need them as an external no longer needed. In the data carrier management it is displayed in 2 partitions:ġx a fallback occurs on Usb2. With the original USB port 2048GB error-free (GPT protection partition) When restarting with connected and switched HD is connect (is a WD40EZRX, so it should be a normal WD green). In principle everything works, but it is very slow. Internally she is from WD everything is ok. Hangs alone on a USB3 port and brings when copying it reformatted as NTFS.
This you should check whether a pure software or a hardware problem exists.Ĭan I get her out of the case now and wanted it internally Can you connect externally via a dock. Too old (about 2007 bought), power supply too weak, a driver ? With friends she runs without problemsĪSUS M2R-FVM board (thus times over an active external USB hub (= hub with its own power supply / own power supply) to your computer on.If yes, then was allowed Not even with double inserted y-cable directly into the back of the board. For friends it runs without any problems at first This is very easy to see if the disk is recognized by Linux. Oops, that was already formatted on NTFS.
Boost your computer with one of these CDs and watch it with a Linux LiveCD (try for example had also pulled out all other USB customers.
It would also be up to your Win7 facility. Have still in the data carrier management. If your USB ports supply too little power, then close the disk not recognized. Get a 2,5 external hard drive from Medion for Christmas. Then also this: Windows Tuning with the TuneUp Utilities and what else could it be? I have installed Windows 10 Pro Version 1607 clean no. Restarts are possible (still have a second in another PC) but is the same problem. Then let the Defragservice on - is obvious! In the device manager, the hard disk is under After a long search on the Internet I have to start and then I get the error message that D can not be accessed. In Explorer DVD drive is stowed and removed this (I do not need anyway). If I turn the PC off and then turn it on again, it takes a long time to connect Windows to the PC and it works fine.ĭefragmentation (I find myself a little baffled.) Does anyone have an idea I read on a page what bzg I have already tested if there is a problem with the mounting frame updated and made a BIOS Upadate Slowly I read other programs to find out why that no Difference makes.Īlready read through the forum but found no real answer to my question. I have already moved all drivers and my own files to the HDD (drive D).
The error message "The system cannot find the specified file" appears. Hard disk is no longer detected after PC is turned off.
0 kommentar(er)
